粉土界面恒刚度循环剪切试验研究

王腾; 张哲

doi:10.11779/CJGE201910017

粉土界面恒刚度循环剪切试验研究 English Version

王腾,
张哲

中国石油大学（华东）船舶与海洋工程系,山东青岛 266580

详细信息

作者简介:
王腾(1973—),男,山东海阳人,博士,教授,主要从事海洋岩土工程方面研究工作。E-mail:wteng73@upc.edu.cn。

计量
- 文章访问数: 0224
- HTML全文浏览量: 0
- PDF下载量: 0138
出版历程
- 收稿日期: 2018-08-24
- 发布日期: 2019-10-24

Experimental studies on cyclic shear behavior of steel-silt interface under constant normal stiffness

Department of Offshore Engineering, China University of Petroleum, Qingdao 266580, China

摘要

摘要: 竖向循环荷载作用下桩土界面的作用机理是研究桩土摩擦疲劳的关键。针对循环荷载作用下桩-粉土界面的剪切性能,使用改进的剪切试验装置在恒刚度条件下进行循环剪切试验,研究循环次数、累积位移和法向刚度对其摩擦疲劳性能、循环后单调剪切性能的影响。试验结果表明,粉土在循环剪切过程中,法向应力和剪应力在初始10个循环内随循环数增加快速衰减,随着循环进行,逐渐趋于稳定;单次循环内在剪切位移方向变化时,土体呈现表现出剪缩-剪胀-剪缩交替现象,总体变形呈现剪缩的趋势;循环荷载作用下,粉土界面的法向应力和剪应力随法向刚度增大衰减速率增大,达到稳定的累积循环位移越小;粉土循环后的单调剪切、法向应力恢复的单调剪切的剪应力比小于首次单调剪切试验值,且法向应力恢复的循环后剪切试验的剪胀程度较小,表明循环剪切过程中界面处粉土颗粒棱角破碎,颗粒变得光滑。在对试验数据分析的基础上,提出了与累积位移、法向刚度和初始应力相关的无量纲累积位移,建立了法向应力和界面摩擦角随累积位移的衰减方程。
- 摩擦疲劳 /
- 循环剪切 /
- 循环后剪切 /
- 粉土 /
- 恒刚度 /
- 累积位移
Abstract: The friction mechanism of pile-soil interface under vertical cyclic loading is the key to study the friction fatigue of piles. In order to study the cyclic shear behavior of pile-silt interface, cyclic shear tests are carried out under constant normal stiffness (CNS) using a modified shear test device. The effects of cycle numbers, cumulative displacement and normal stiffness on the friction fatigue performance and post-cyclic monotonic shear behavior are studied. The results show that the normal and shear stresses decrease rapidly in the initial 10 cycles and gradually become stable with the cycle. The soil exhibits shearing contraction, dilatation and contraction alternating phenomenon with the shear displacement direction changing in a single cycle, and the overall deformation shows a tendency of shearing contraction. The higher normal stiffness results in higher reduction rate of the normal and shear stresses in the shear interface, and the cumulative cyclic displacement for cyclic stability is smaller. The shear stress ratios from the post-cyclic monotonic and post-cyclic monotonic shear tests with the same initial normal stress are lower than those from the initial monotonic shear tests, and the post-cyclic monotonic shears from the same initial normal stress tests have low shear dilation degree, which indicates that the soil sample experiences particle crushing and soil particles become smooth due to the cyclic shearing effect. Based on the analysis of experimental data, the dimensionless cumulative displacement related to the cumulative displacement, normal stiffness and initial normal stress is proposed. The attenuation equation for the normal stress and interface friction angle with cumulative displacement is established.
- friction fatigue /
- cyclic shear /
- post-cyclic shear /
- silt /
- constant normal stiffness /
- cumulative displacement

HTML全文

参考文献(23)

[1]	LEHANE B, JARDINE R J.The behavior of a displacement pile in Bothkennar clay[C]// Predictive Soil Mechanics. London, 1993.
[2]	LEHANE B M.Experimental investigations of pile behaviour using instrumented field piles[D]. London: The University of London, 1992.
[3]	WHITE D J, LEHANE B M.Friction fatigue on displacement piles in sand[J]. Géotechnique, 2004, 54(10): 645-658.
[4]	WHITE D J, BOLTON M D.Comparing CPT and pile base resistance in sand[J]. Geotechnical Engineering, 2005, 158(1): 3-14.
[5]	JARDINE R J, LEHANE B M,BOND A J, et al.Mechanisms of shaft friction in sand from instrumented pile tests[J]. Journal of Geotechnical Engineering, 2010, 119(1): 19-35.
[6]	俞峰, 谭国焕, 杨峻, 等. 粗粒土中预制桩的静压施工残余应力[J]. 岩土工程学报, 2011, 33(10): 1526-1536. (YU Feng, THAM L G, YANG Jun, et al.Post-installation residual stress in performed piles jacked into granular soils[J]. Chinese Journal of Geotechnical Engineering, 2011, 33(10): 1526-1536. (in Chinese))
[7]	HEEREMA E P.Predicting pile drive ability: heather as an illustration of the friction fatigue theory[J]. Ground Engineering, 1980, 13(2): 15-37.
[8]	JARDINE R J, CHOW F C, MATSUMOTO T, et al.A new design procedure for driven piles and its application to two Japanese clays[J]. Journal of the Japanese Geotechnical Society Soils & Foundation, 2008, 38(1): 207-219.
[9]	CARNEIRO D, WHITE D J, DANZIGER F A B, et al. A novel approach for time-dependent axial soil resistance in the analysis of subsea pipelines[J]. Computers & Geotechnics, 2015, 69(10): 641-651.
[10]	BOULON M, FORAY P.Physical and numerical simulation of lateral shaft friction along offshore piles in sand[C]// Numerical Method in Offshore Piling. Nantes, 1986.
[11]	刘俊伟, 张忠苗, 俞峰, 等. 基于恒刚度剪切试验的预制桩侧阻退化估计[J]. 岩土工程学报, 2012, 34(4): 725-729. (LIU Jun-wei, ZHANG Zhong-miao, YU Feng, et al.Estimation of friction fatigue for preformed piles based on constant normal stiffness shear test[J]. Chinese Journal of Geotechnical Engineering, 2012, 34(4): 725-729. (in Chinese))
[12]	AIREY D W, Al DOURI, POULOS H G.Estimation of pile friction degradation from shearbox tests[J]. Geotechnical Testing Journal, 1992, 15(4): 388-392.
[13]	MORTARA G, MANGIOLA A, Ghionna V N.Cyclic shear stress degradation and post-cyclic behavior from sand-steel interface direct shear tests[J]. Canadian Geotechnical Journal, 2007, 44(7): 739-752
[14]	PRA AI S, BOULON M.Soil-structure cyclic direct shear tests: a new interpretation of the direct shear experiment and its application to a series of cyclic tests[J]. Acta Geotechnica, 2017, 12(1): 107-127.
[15]	LEHANE B M, WHITE D J.Lateral stress changes and shaft friction for model displacement piles[J]. Canadian Geotechnical Journal, 2005, 42(4): 1039-1052.
[16]	JOHNSTON I W, LAM T S K, WILLIAMS A F. Constant normal stiffness direct shear testing for socketed pile design in weak rock[J]. Géotechnique, 1987, 37(1): 83-89.
[17]	贾尚华, 赵春风, 赵程. 砂土中柱孔扩张问题的扩孔压力与扩孔半径分析[J]. 岩石力学与工程学报, 2015, 34(1): 182-188. (JIA Shang-hua, ZHAO Chun-feng, ZHAO Cheng.Analysis of expanded radius and internal expanding pressure of cylindrical hole[J]. Chinese Journal of Rock Mechanics and Engineering, 2015, 34(1): 182-188. (in Chinese))
[18]	POULOS H G.Pile behavior-theory and application[J]. Géotechnique, 1989, 39(3): 365-415
[19]	FAKHARIAN K, EVGIN E.Cyclic simple-shear behavior of sand-steel interfaces under constant normal stiffness condition[J]. Journal of Geotechnical & Geoenvironmental Engineering, 1997, 123(12): 1096-1105.
[20]	ALSHIBLI K A, ALSALEH M I.Characterizing surface roughness and shape of sands using digital microscopy[J]. Journal of Computing in Civil Engineering, 2004, 18(1): 36-45.
[21]	ALSALEH M I, ALSHIBLI K A, VOYIADJIS G Z.Influence of micromaterial heterogeneity on strain localization in granular materials[J]. International Journal of Geomechanics, 2006, 6(4): 248-259.
[22]	American Petroleum Institute.Recommended practice for planning, designing and constructing fixed offshore platforms (API RP2A)[M]. 22nd ed. Washington D C: Official Press of US, 2014.
[23]	RANDOLPH M F, DOLWIN R, BECK R.Design of driven piles in sand[J]. Géotechnique, 1994, 44(3): 427-448.

施引文献(12)

期刊类型引用(5)

1.	何冬，于爽. 不同应力水平下钢-粉质黏土恒刚度界面循环剪切特性研究. 科技通报. 2025(04): 64-72 . 百度学术
2.	金佳旭，袁士豪，梁冰，李世旺，刘家顺，周克林. 摩擦桩-砂土接触面剪切特性可视化试验研究. 实验力学. 2022(04): 551-560 . 百度学术
3.	于鹏，刘灿，刘红军，于雅琼. 黄河三角洲粉土-钢界面大型剪切试验研究. 中国海洋大学学报(自然科学版). 2021(09): 71-79 . 百度学术
4.	汪远，邓检良，黄凤荣. 测量不规则块体界面摩擦角的滚筒实验. 实验室研究与探索. 2021(07): 10-15 . 百度学术
5.	王永洪，桑松魁，刘雪颖，张明义，白晓宇. 层状黏性土中静压桩贯入特性颗粒流的数值模拟. 西南交通大学学报. 2021(06): 1250-1259 . 百度学术

其他类型引用(7)

资源附件(0)

计量

文章访问数:
HTML全文浏览量: 0
PDF下载量:
被引次数: 12

粉土界面恒刚度循环剪切试验研究 English Version

作者简介: 王腾(1973—),男,山东海阳人,博士,教授,主要从事海洋岩土工程方面研究工作。E-mail:wteng73@upc.edu.cn。

计量

出版历程

Experimental studies on cyclic shear behavior of steel-silt interface under constant normal stiffness

期刊类型引用(5)

其他类型引用(7)

计量

出版历程

目录

作者简介:
王腾(1973—),男,山东海阳人,博士,教授,主要从事海洋岩土工程方面研究工作。E-mail:wteng73@upc.edu.cn。