[1] |
LAM W, TATSUOKA F.Effects of initial anisotropic fabric and on strength and deformation characteristics of sand[J]. Soils and Foundations, 1988, 28(1): 89-106.
|
[2] |
KIRKGARD M M, LADE P V.Anisotropic three-dimensional behavior of a normally consolidated clay[J]. Canadian Geotechnical Journal, 1993, 30(5): 848-858.
|
[3] |
王洪瑾, 张国平, 周克骥. 固有和诱发各向异性对击实粘性土强度和变形特性的影响[J]. 岩土工程学报, 1996, 18(3): 1-10. (WANG Hong-jin, ZHANG Guo-ping, ZHOU Ke-ji.Effects of inherent and induced anisotropy on strength and deformation characteristics of compacted cohesive soil[J]. Chinese Journal of Geotechnical Engineering, 1996, 18(3): 1-10. (in Chinese))
|
[4] |
LADE P V, RODRIGUEZ N M, VAN DYCK E J. Effects of principal stress directions on 3D failure conditions in cross- anisotropic sand[J]. Journal of Geotechnical and Geoenvironmental Engineering, 2014, 140(2): 1-12.
|
[5] |
ODA M, KOISHIKAWA I, HIGUCHI T.Experimental study of anisotropic shear strength of sand by plane strain test[J]. Soils and Foundations, 1978, 18(1): 25-38.
|
[6] |
ZDRAVKOVIC L, POTTS D M, HIGHT D W.The effect of strength anisotropy on the behaviour of embankments on soft ground[J]. Géotechnique, 2002, 52(6): 447-457.
|
[7] |
殷宗泽, 张坤勇, 朱俊高. 面板堆石坝应力变形计算中考虑土的各向异性[J]. 水利学报, 2004, 35(11): 22-26. (YIN Zong-ze, ZHANG Kun-yong, ZHU Jun-gao.Considering soil’s anisotropy in the calculation of stress deformation of concret-faced rockfill dam[J]. Journal of Hydraulic Engineering, 2012, 43(1): 43-50. (in Chinese))
|
[8] |
陈越. 粒状材料强度异向性的物理实质和数学表现形式[J]. 岩土工程学报, 1992, 14(1): 1-13. (CHEN Yue.Physical essence and mechanical expressions of strength-anisotropy for granular materials[J]. Chinese Journal of Geotechnical Engineering, 1992, 14(1): 1-13. (in Chinese))
|
[9] |
姚仰平, 祝恩阳. 横观各向同性土的简明破坏机制解释[J]. 岩土力学, 2014, 35(2): 328-333. (YAO Yang-ping, ZHU En-yang.Concise interpretation of damage mechanism for cross-anisotropic soil[J]. Rock and Soil Mechanics, 2014, 35(2): 328-333. (in Chinese))
|
[10] |
ABELEV A V, LADE P V.Characterization of failure in cross-anisotropic soils[J]. Journal of Engineering Mechanics. 2004, 130(5): 599-606.
|
[11] |
MORTARA G.A yield criterion for isotropic and cross- anisotropic cohesive-frictional materials[J]. International Journal for Numerical and Analytical Methods in Geomechanics, 2010, 34(10): 953-977.
|
[12] |
LÜ X L, HUANG M S, QIAN J G.The onset of strain localization in cross-anisotropic soils under true triaxial condition[J]. Soils and Foundations, 2011, 51(4): 693-700.
|
[13] |
GAO Z W, ZHAO J D, YAO Y P.A generalized anisotropic failure criterion for geomaterials[J]. International Journal of Solids and Structures, 2010, 47(22/23): 3166-3185.
|
[14] |
GAO Z W, ZHAO J D.Efficient approach to characterize strength anisotropy in soils[J]. Journal of Engineering Mechanics, 2012, 138(12): 1447-1456.
|
[15] |
李学丰, 黄茂松, 钱建固. 宏细观结合的砂土各向异性破坏准则[J]. 岩石力学与工程学报, 2010, 29(9): 1885-1892. (LI Xue-feng, HUANG Mao-song, QIAN Jian-gu.Failure criterion of anisotropic sand with method of macro-meso incorporation[J]. Chinese Journal of Rock Mechanics and Engineering, 2010, 29(9): 1885-1892. (in Chinese))
|
[16] |
刘洋. 砂土的各向异性强度准则:原生各向异性[J]. 岩土工程学报, 2013, 35(8): 1526-1534. (LIU Yang.Anisotropic strength criteria of sand: inherent anisotropy[J]. Chinese Journal of Geotechnical Engineering, 2013, 35(8): 1526-1534. (in Chinese))
|
[17] |
TOBITA Y, YANAGISAWA E.Modified stress tensors for anisotropic behavior of granular materials[J]. Soils and Foundations, 1992, 32(1): 85-99.
|
[18] |
YAO Y P, TIAN Y, GAO Z W.Anisotropic UH model for soils based on a simple transformed stress method[J]. International Journal for Numerical and Analytical Methods in Geomechanics, 2017, 41(1): 54-78.
|
[19] |
PIETRUSZCZAK S, MROZ Z.Formulation of anisotropic failure criteria incorporating a microstructure tensor[J]. Computers and Geotechnics, 2000, 26(2): 105-112.
|
[20] |
LADE P V.Modeling failure in cross-anisotropic frictional materials[J]. International Journal of Solids and Structures, 2007, 44(16): 5146-5162.
|
[21] |
KONG Y X, ZHAO J D, YAO Y P.A failure criterion for cross-anisotropic soils considering microstructure[J]. Acta Geotechnica, 2013, 8(6): 665-673.
|
[22] |
罗汀, 李萌, 孔玉侠, 等. 基于SMP的岩土各向异性强度准则[J]. 岩土力学, 2009, 30(增刊2): 127-131. (LUO Ting, LI Meng, KONG Yu-xia, et al.Failure criterion based on SMP for anisotropic geomaterials[J]. Rock and Soil Mechanics, 2009, 30(S2): 127-131. (in Chinese))
|
[23] |
LIU M D, INDRARATNA B N.General strength criterion for geomaterials including anisotropic effect[J]. International Journal of Geomechanics, 2011, 11(3): 251-261.
|
[24] |
姚仰平, 孔玉侠. 横观各向同性土强度与破坏准则的研究[J]. 水利学报, 2012, 39(1): 43-50. (YAO Yang-ping, KONG Yu-xia.Research on the cross-anisotropic soil’s strength and failure criterion[J]. Journal of Hydraulic Engineering, 2012, 39(1): 43-50. (in Chinese))
|
[25] |
YAO Y P, KONG Y X.Extended UH model: three- dimensional unified hardening model for anisotropic clays[J]. Journal of Engineering Mechanics, 2012, 138(7): 853-866.
|
[26] |
张连卫, 张建民, 张嘎. 基于SMP的粒状材料各向异性强度准则[J]. 岩土工程学报, 2008, 30(8): 1107-1111. (ZHANG Lian-wei, ZHANG Jian-min, ZHANG Ga.SMP-based anisotropic strength criteria of granular materials[J]. Chinese Journal of Rock Mechanics and Engineering, 2008, 30(8): 1107-1111. (in Chinese))
|
[27] |
MATSUOKA H.Stress-strain relationships of sands based on the mobilized plane[J]. Soils and Foundations, 1974, 14(2): 47-61.
|
[28] |
路德春, 杜修力. 岩石材料的非线性强度与破坏准则研究[J]. 岩石力学与工程学报. 2013, 32(12): 2394-2408. (LU De-chun, DU Xiu-li.Research on nonlinear strength and failure criterion of rock material[J]. Chinese Journal of Rock Mechanics and Engineering, 2013, 32(12): 2394-2408. (in Chinese))
|
[29] |
路德春, 姚仰平, 邹博. 广义非线性强度理论体系[J]. 岩土力学, 2007, 28(10): 2009-2016. (LU De-chun, YAO Yang-ping, ZOU Bo.System of generalized nonlinear strength theory[J]. Rock and Soil Mechanics, 2007, 28(10): 2009-2016. (in Chinese))
|
[30] |
LADE P V, RODRIGUEZ N M, VAN DYCK E J. Effects of principal stress directions on 3D failure conditions in cross-anisotropic sand[J]. Journal of Geotechnical and Geoenvironmental Engineering, 2014, 140(2): 1-12.
|
[31] |
MATSUOKA H, JUN-ICHI H, KIYOSHI H.Deformation and failure of anisotropic sand deposits[J]. Soil Mechanics and Foundation Engineering, 1984, 32(11): 31-36.
|
[32] |
LÜ X L, HUANG M S, ANDRADE J E.Strength criterion for cross-anisotropic sand under general stress conditions[J]. Acta Geotechnica. 2016, 11(6): 1339-1350.
|
[33] |
LU D C, MA C, DU X L, et al.Development of a new nonlinear unified strength theory for geomaterials based on the characteristic stress concept[J]. International Journal of Geomechanics, 2017, 17(2): 1-11.
|
[34] |
杜修力, 马超, 路德春. 岩土材料的非线性统一强度模型[J]. 力学学报, 2014, 46(3): 389-397. (DU Xiu-li, MA Chao, LU De-chun.Nonlinear unified strength model of geomaterials[J]. Chinese Journal of Theoretical and Applied Mechanics, 2014, 46(3): 389-397. (in Chinese))
|
[35] |
杜修力, 马超, 路德春. 岩土类材料的静水压力效应[J]. 岩石力学与工程学报, 2015, 34(3): 572-582. (DU Xiu-li, MA Chao, LU De-chun.Effect of hydrostatic pressure on geomaterials[J]. Chinese Journal of Rock Mechanics and Engineering, 2015, 34(3): 572-582. (in Chinese))
|
[36] |
LADE P V, NAM J, HONG W P.Shear banding and cross-anisotropic behavior observed in laboratiory sand tests with stress rotation[J]. Canadian Geotechnical Journal, 2008, 45(1): 74-84.
|