Citation: | LIANG Shan-zhai. Field tests on vertical bearing capacity of pipe piles in cement-improved soil[J]. Chinese Journal of Geotechnical Engineering, 2021, 43(S2): 280-283. DOI: 10.11779/CJGE2021S2065 |
[1] |
董平, 陈征宙, 秦然. 混凝土芯水泥土搅拌桩在软土地基中的应用[J]. 岩土工程学报, 2002, 24(2): 204-207. doi: 10.3321/j.issn:1000-4548.2002.02.017
DONG Ping, CHEN Zheng-zhou, QIN Ran. Use of concrete-cored DCM pile in soft ground[J]. Chinese Journal of Geotechnical Engineering, 2002, 24(2): 204-207. (in Chinese) doi: 10.3321/j.issn:1000-4548.2002.02.017
|
[2] |
李俊才, 张永刚, 邓亚光, 等. 管桩水泥土复合桩荷载传递规律研究[J]. 岩石力学与工程学报, 2014, 33(增刊1): 3068-3076. doi: 10.13722/j.cnki.jrme.2014.s1.068
LI Jun-cai, ZHANG Yong-gang, DENG Ya-guang, et al. Load transfer mechanism of composite pile composed of jet-mixing cement and phc pile with core concrete[J]. Chinese Journal of Rock Mechanics and Engineering, 2014, 33(S1): 3068-3076. (in Chinese) doi: 10.13722/j.cnki.jrme.2014.s1.068
|
[3] |
吴迈, 窦远明, 王恩远. 水泥土组合桩荷载传递试验研究[J]. 岩土工程学报, 2004, 26(3): 432-434. doi: 10.3321/j.issn:1000-4548.2004.03.029
WU Mai, DOU Yuan-ming, WANG En-yuan. A study on load transfer mechanism of stiffened DCM pile[J]. Chinese Journal of Geotechnical Engineering, 2004, 26(3): 432-434. (in Chinese) doi: 10.3321/j.issn:1000-4548.2004.03.029
|
[4] |
李立业. 水泥土复合管桩承载特性研究[D]. 南京: 东南大学, 2016.
LI Li-ye. Study on the Bearing Capacity of Stiffened DCM Pile[D]. Nanjing: Southeast University, 2016. (in Chinese)
|
[5] |
叶观宝, 蔡永生, 张振. 加芯水泥土桩复合地基桩土应力比计算方法研究[J]. 岩土力学, 2016, 37(3): 672-678. doi: 10.16285/j.rsm.2016.03.008
YE Guan-bao, CAI Yong-sheng, ZHANG Zhen. Research on calculation of pile-soil stress ratio for composite foundation reinforced by stiffened deep mixed piles[J]. Rock and Soil Mechanics, 2016, 37(3): 672-678. (in Chinese) doi: 10.16285/j.rsm.2016.03.008
|
[6] |
JAMSAWANG P, BERGADO D T, VOOTTIPRUEX P. Field behaviour of stiffened deep cement mixing piles[J]. Proceedings of the ICE-Ground Improvement, 2010, 164(1): 33-49.
|
[7] |
钱于军, 许智伟, 邓亚光等. 劲性复合管桩的工程应用与试验分析[J]. 岩土工程学报, 2013, 35(增刊2): 998-1001. https://www.cnki.com.cn/Article/CJFDTOTAL-YTGC2013S2190.htm
QIAN Yu-jun, XU Zhi-wei, DENG Ya-guang, et al.Engineering application and test analysis of strength composite piles[J]. Chinese Journal of Geotechnical Engineering, 2013, 35(S2): 998-1001. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-YTGC2013S2190.htm
|
[8] |
VOOTTIPRUEX P, SUKSAWAT T, BERGADO D T, et al. Numerical simulations and parametric study of SDCM and DCM piles under full scale axial and lateral loads[J]. Computers and Geotechnics, 2011, 38(3): 318-329. doi: 10.1016/j.compgeo.2010.11.006
|
[9] |
WONGLERT A, JONGPRADIST P. Impact of reinforced core on performance and failure behavior of stiffened deep cement mixing piles[J]. Computers and Geotechnics, 2015, 69: 93-104. doi: 10.1016/j.compgeo.2015.05.003
|
[10] |
WANG A H, ZHANG D W, DENG Y G. A simplified approach for axial response of single precast concrete piles in cement-treated soil[J]. International Journal of Civil Engineering, 2018, 16(10): 1491-1501. doi: 10.1007/s40999-018-0341-9
|
[11] |
WANG A H, ZHANG D W, DENG Y G.. Lateral response of single piles in cement-improved soil: numerical and theoretical investigation[J]. Computers and Geotechnics, 2018, 102: 164-178. doi: 10.1016/j.compgeo.2018.06.014
|
[12] |
王安辉, 章定文, 谢京臣. 软黏土中劲性复合桩水平承载特性p-y 曲线研究[J]. 岩土工程学报, 2020, 42(2): 381-389. https://www.cnki.com.cn/Article/CJFDTOTAL-XBKJ201129003.htm
WANG An-hui, ZHANG Ding-wen, XIE Jing-chen. p-y curves for lateral bearing behavior of strength composite piles in soft clay[J]. Chinese Journal of Geotechnical Engineering, 2020, 42(2): 381-389. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-XBKJ201129003.htm
|
[1] | YANG Xu, CAI Guoqing, LIU Qianqian, LI Fengzeng, SHAN Yepeng. Experimental study on influences of wetting-drying cycles on microstructure and water-retention characteristics of clay[J]. Chinese Journal of Geotechnical Engineering, 2024, 46(S2): 11-15. DOI: 10.11779/CJGE2024S20006 |
[2] | QI Yongzheng, HAO Yunjie, WU Silin, ZHOU Aizhao, ZHU Zhongquan, YANG Ziming, JIN Yongjie. Effects of ultrasonic duration on performance of sludge dewatering[J]. Chinese Journal of Geotechnical Engineering, 2023, 45(S1): 84-87. DOI: 10.11779/CJGE2023S10056 |
[3] | ZHU Weibin, LIU Chang, ZHONG Xiaochun, YOU Zhi, ZHU Nengwen. Performance evaluation of shield tail brushes based on compression and grease escape tests[J]. Chinese Journal of Geotechnical Engineering, 2023, 45(5): 1086-1093. DOI: 10.11779/CJGE20211421 |
[4] | LIU Yong-chao, YUAN Zhen-yu, CHENG Xue-song, LI Gang, ZHANG Tian-xing, LI Qing-han. Experimental study on plugging effect of different grouting materials for water and sand leakage of tunnels[J]. Chinese Journal of Geotechnical Engineering, 2021, 43(S2): 249-252. DOI: 10.11779/CJGE2021S2059 |
[5] | TANG Zhao-guang, WANG Yong-zhi, DUAN Xue-feng, SUN Rui, WANG Ti-qiang. Development and performance evaluation of separable high-frequency response miniature pore water pressure transducer[J]. Chinese Journal of Geotechnical Engineering, 2021, 43(7): 1210-1219. DOI: 10.11779/CJGE202107005 |
[6] | ZHANG Wen-jun, CAO Wen-zhen. Mechanical and waterproof performances of joints of shield tunnels with large cross-section under earthquakes[J]. Chinese Journal of Geotechnical Engineering, 2021, 43(4): 653-660. DOI: 10.11779/CJGE202104007 |
[7] | LI Zhao-feng, GAO Yi-fan, ZHANG Jian, QI Yan-hai, WANG Yan-sheng, LIU Chao. Experimental study of water-soluble vegetable gum-modified cement-sodium silicate plugging materials[J]. Chinese Journal of Geotechnical Engineering, 2020, 42(7): 1312-1321. DOI: 10.11779/CJGE202007015 |
[8] | Research on the Failure Mode and the Compression Strength for the Frozen Clay at Different Temperature Gradients[J]. Chinese Journal of Geotechnical Engineering, 2010, 32(12): 1856-1860. |
[9] | Development and application of new waterproof grouting materials of polyurethane[J]. Chinese Journal of Geotechnical Engineering, 2010, 32(3). |
[10] | HAO Zhe, WANG Yinggang, LIU Bin. Reliability design of grouting for stopping up water in rock mass[J]. Chinese Journal of Geotechnical Engineering, 2002, 24(5): 592-595. |