Nonlinear analysis of load transfer of grouting branch-type anchor

YANG Jian; JIAN Wen-bin; HUANG Wei; HUANG Cong-hui; LUO Jin-mei; LI Xian-zhong

doi:10.11779/CJGE202110016

Volume 43 Issue 10

Turn off MathJax

Article Contents

Abstract

References

Chinese Journal of Geotechnical Engineering > 2021 > 43(10): 1896-1904. > DOI: 10.11779/CJGE202110016

YANG Jian, JIAN Wen-bin, HUANG Wei, HUANG Cong-hui, LUO Jin-mei, LI Xian-zhong. Nonlinear analysis of load transfer of grouting branch-type anchor[J]. Chinese Journal of Geotechnical Engineering, 2021, 43(10): 1896-1904. DOI: 10.11779/CJGE202110016

Citation:

PDF (3125 KB)

Nonlinear analysis of load transfer of grouting branch-type anchor

1.
Institute of Geotechnical and Geological Engineering, College of Environment and Resources, Fuzhou University, Fuzhou 350116, China
2.
Key Laboratory of Geohazard Prevention of Fujian Province, Fuzhou University, Fuzhou 350003, China
3.
Fujian Geological Exploration Institute of Geology and Mine Bureau, Fuzhou 350013, China

More Information

Received Date: November 29, 2020
Available Online: December 02, 2022

Graphical Abstract

Abstract

Abstract

Based on the indoor model pull-out tests on the branch-type anchor, the variation characteristics of the load-displacement curve and the axial force transmission characteristics are studied. Then, the mechanical model for the anchor is discussed, and the theoretical formula for the end resistance of disc is derived. Combined with the hyperbolic nonlinear model for the anchor-soil interface, the load transfer model is established by using the sectional deformation coordinated iterative algorithm. Finally, the sensitivity analysis of the parameters such as the ultimate pressure of cavity expansion distribution and the squeezing angle of the branch disc is performed. The results show that the load displacement curve can be divided into three stages. The axial force distribution decreases along the anchor depth and the step mutation occurs at the branch disc, and the load ratio also increases continuously. The calculated results are basically consistent with the indoor measured data, which verifies the validity of the model. The ultimate pressure of cavity expansion increases rapidly and nonlinearly along the radial direction of the branch disc and then decreases slowly. The peak value increases with the displacement and moves radially outward with the center of the branch disc as the circular point. The overall distribution changes from "cone platform" to "cylinder". When the squeezing angle is greater than 50°, the ultimate drawing force significantly increases. The research results are of important theoretical and practical significance for the analysis and design of the force of the branch-type anchor.
- branch-type anchor,
- cavity theory expansion,
- nonlinearity,
- load transfer,
- numerical calculation

FullText(HTML)

References (26)

References

[1]	程良奎, 张培文, 王芳. 岩土锚固工程的若干力学概念问题[J]. 岩石力学与工程学报, 2015, 34(4): 668-682. CHENG Liang-kui, ZHANG Pei-wen, WANG Fang. Several mechanical concepts for anchored structures in rock and soil[J]. Chinese Journal of Rock Mechanics and Engineering, 2015, 34(4): 668-682. (in Chinese)
[2]	简文彬, 黄炜, 罗金妹, 等. 多支盘锚固结构[P]. CN211256969U, 2020-08-14. JIAN Wen-bin, HUANG Wei, LUO Jin-mei, et al. Multi-branch Anchor Structure: CN211256969U[P]. 2020-08-14. (in Chinese)
[3]	简文彬, 杨坚, 罗金妹, 等. 一种多支盘锚固体系扩孔设备及施工方法[P]. CN110700760A, 2020-01-17. JIAN Wen-bin, YANG Jian, LUO Jin-mei, et al. Hole Reaming Equipment and Construction Method of Multi- Branch Anchor Solid System[P]. CN110700760A. 2020-01-17. (in Chinese)
[4]	杨坚, 简文彬, 黄炜, 等. 注浆支盘式锚杆拉拔试验及极限承载力计算[J]. 岩土力学, 2021, 42(4): 1126-1132. YANG Jian, JIAN Wen-bin, HUANG Wei, et al. Pull-out test and ultimate bearing capacity calculation of grouting branch-type anchor[J]. Rock and Soil Mechanics, 2021, 42(4): 1126-1132. (in Chinese)
[5]	NIE W, ZHAO Z Y, NING Y J, et al. Numerical studies on rockbolts mechanism using 2D discontinuous deformation analysis[J]. Tunnelling and Underground Space Technology, 2014, 41(1): 223-233.
[6]	MA S Q, NEMCIK J, AZIZ N. An analytical model of fully grouted rock bolts subjected to tensile load[J]. Construction and Building Materials, 2013, 49(8): 519-526.
[7]	NEMCIK J, MA S, AZIZ N, et al. Numerical modelling of failure propagation in fully grouted rock bolts subjected to tensile load[J]. International Journal of Rock Mechanics and Mining Sciences, 2014, 71(10): 293-300.
[8]	MA S Q, ZHAO Z Y, NIE W, et al. An analytical model for fully grouted rockbolts with consideration of the pre- and post-yielding behavior[J]. Rock Mechanics and Rock Engineering, 2017, 50(11): 3019-3028.
[9]	NI P, SONG L, MEI G, et al. Generalized nonlinear softening load-transfer model for axially loaded piles[J]. International Journal of Geomechanics, 2017, 17(8): 04017019.
[10]	BRYSON L S, GIRALDO J R. Analysis of case study presenting ground anchor load-transfer response in shale stratum[J]. Canadian Geotechnical Journal, 2020, 57(1): 85-99.
[11]	陈建功, 陈晓东. 基于小波函数的锚杆拉拔全过程分析[J]. 岩土力学, 2019, 40(12): 4590-4596. CHEN Jian-gong, CHEN Xiao-dong. Analysis of whole process of bolt pulling based on wavelet function[J]. Rock and Soil Mechanics, 2019, 40(12): 4590-4596. (in Chinese)
[12]	黄明华, 赵明华, 陈昌富. 锚固长度对锚杆受力影响分析及其临界值计算[J]. 岩土力学, 2018, 39(11): 4033-4041. HUANG Ming-hua, ZHAO Ming-hua, CHEN Chang-fu. Influence of anchorage length on stress in bolt and its critical value calculation[J]. Rock and Soil Mechanics, 2018, 39(11): 4033-4041. (in Chinese)
[13]	匡政, 白晓宇, 张明义, 等. 考虑锚固体不均匀及杆体脱黏效应的GFRP抗浮锚杆杆体荷载分布函数[J]. 岩石力学与工程学报, 2019, 38(6): 1158-1171. KUANG Zheng, BAI Xiao-yu, ZHANG Ming-yi, et al. Load distribution function of GFRP anti-floating anchors considering the anchorage body unevenness and the anchor debonding effect[J]. Chinese Journal of Rock Mechanics and Engineering, 2019, 38(6): 1158-1171. (in Chinese)
[14]	土工试验标准方法：GB/T50123—2019[S]. 2019. Standard for Soil Test Method: GB/T50123—2019[S]. 2019. (in Chinese)
[15]	建筑基坑支护技术规程：JGJ 120—2012[S]. 2012. Technical Specification for Building Foundation Pit Support: JGJ 120—2012[S]. 2012. (in Chinese)
[16]	LIU J, LIU M, ZHU Z. Sand deformation around an uplift plate anchor[J]. Journal of Geotechnical & Geoenvironmental Engineering, 2012, 138(6): 728-737.
[17]	胡伟, 孟建伟, 姚琛, 等. 浅埋平板圆锚竖向拉拔极限承载力计算方法[J]. 岩土力学, 2020, 41(9): 3049-3055. HU Wei, MENG Jian-wei, YAO Chen, et al. Calculation method of vertical pullout ultimate bearing capacity of shallow circular anchor plate[J]. Rock and Soil Mechanics, 2020, 41(9): 3049-3055. (in Chinese)
[18]	史旦达, 毛逸瑶, 杨勇, 等. 基于DIC技术的砂土中圆形锚板上拔土体变形特性试验研究[J]. 岩土力学, 2020, 41(10): 3201-3213. SHI Dan-da, MAO Yi-yao, YANG Yong, et al. Experimental study on the deformation characteristics of soils around uplift circular plate anchors using digital image correlation technology[J]. Rock and Soil Mechanics, 2020, 41(10): 3201-3213. (in Chinese)
[19]	VESIC A S. Expansion of cavities in infinite soil mass[J]. Journal of the Soil Mechanics and Foundations Division, 1972, 98(3): 265-290.
[20]	刘裕华, 陈征宙, 彭志军, 等. 应用圆孔柱扩张理论对预制管桩的挤土效应分析[J]. 岩土力学, 2007, 28(10): 2167-2172. LIU Yu-hua, CHEN Zheng-zhou, PENG Zhi-jun. Analysis of pile driving effect of precast tubular pile using cylindrical cavity expansion theory[J]. Rock and Soil Mechanics, 2007, 28(10): 2167-2172. (in Chinese)
[21]	王伟堂, 裘华君, 詹红琴. 压桩挤土位移的预估与防治的研究[J]. 岩土工程学报, 2001, 23(3): 378-379. WANG Wei-tang, QIU Hua-jun, ZHAN Hong-qin. Study on prediction and prevention for soil displacement caused by the statically pressed piles[J]. Chinese Journal of Geotechnical Engineering, 2001, 23(3): 378-379. (in Chinese)
[22]	郑颖人, 龚晓南. 岩土塑性力学基础[M]. 北京: 中国建筑工业出报社, 1989. ZHENG Ying-ren, GONG Xiao-nan. Fundamentals of Geotechnics Plasticity[M]. Beijing: China Architecture & Building Press, 1989. (in Chinese)
[23]	FARMER I W. Stress distribution along a resin grouted rock anchor[J]. International Journal of Rock Grouted Rock Mechanics Mining Science & Geomechanics Abstract, 1975, 12(11): 347-351.
[24]	赵明华, 黄炎杰, 黄明华. 基于有限差分法的锚杆荷载传递非线性计算方法研究[J]. 铁道科学与工程学报, 2018, 15(8): 1963-1970. ZHAO Ming-hua, HUANG Yan-jie, HUANG Ming-hua. Study on nonlinear calculation method of load transferring along tensile anchor rod base on finite difference method[J]. Journal of Railway Science and Engineering, 2018, 15(8): 1963-1970. (in Chinese)
[25]	张季如, 唐保付. 锚杆荷载传递机理分析的双曲函数模型[J]. 岩土工程学报, 2002, 24(2): 188-192. KUANG Zheng, ZHANG Ji-ru, TANG Bao-fu, et al. Hyperbolic function model to analyze load transfer mechanism on bolts[J]. Chinese Journal of Geotechnical Engineering, 2002, 24(2): 188-192. (in Chinese)
[26]	RANDOLPH M F, WROTH C P. An analysis of vertical deformation of piles groups[J]. Géotechnique, 1979, 29(4): 423-439.