• 全国中文核心期刊
  • 中国科技核心期刊
  • 美国工程索引(EI)收录期刊
  • Scopus数据库收录期刊
YAO Yang-ping, LIU Lin, LUO Ting. UH model for sands[J]. Chinese Journal of Geotechnical Engineering, 2016, 38(12): 2147-2153. DOI: 10.11779/CJGE201612002
Citation: YAO Yang-ping, LIU Lin, LUO Ting. UH model for sands[J]. Chinese Journal of Geotechnical Engineering, 2016, 38(12): 2147-2153. DOI: 10.11779/CJGE201612002

UH model for sands

More Information
  • Received Date: August 17, 2016
  • Published Date: December 24, 2016
  • By analyzing the behaviours of sands, a constitutive model for sands is proposed based on the UH model. The model has the following characteristics: (1) the model can describe that the isotropic compression line of sands is a curve in the e-lnp plane by introducing a compressive hardening parameter. (2) The stress ratio at the characteristic state point of loose sand is relatively large, and that of dense sand is relatively small, which can be described by the new model by introducing a dilatancy parameter. (3) The yield surface of sands is proposed by introducing a critical state parameter, and the position of the critical state line (CSL) in the e-lnp plane can be accurately described by the proposed model. Compared with the UH model, the proposed model requires three additional sand parameters which can be determined by the conventional triaxial tests. Finally, the validity of the new model is confirmed by the data from triaxial drained and undrained compression tests for sands.
  • [1]
    LADE P V, DUNCAN J M. Elasto-plastic stress-strain theory for cohesionless soil[J]. Journal of the Geotechnical Engineering Division, 1975, 101(10): 1037-1053.
    [2]
    BEEN K, JEFFERIES M G, HACHEY J. The critical state of sands[J]. Géotechnique, 1992, 42 (4): 655-663.
    [3]
    LI X S, DAFALIAS Y F. Dilatancy for cohesionless soils[J]. Géotechnique, 2000, 50(4): 449-460.
    [4]
    POOROOSHASB H B, HOLUBEC I, SHERBOURNE A N. Yielding and flow of sand in triaxial compression, Part I[J]. Canadian Geotechnical Journal, 1966, 3(5): 179-190.
    [5]
    POOROOSHASB H B, HOLUBEC I, SHERBOURNE A N. Yielding and flow of sand in triaxial compression, Part II[J]. Canadian Geotechnical Journal, 1967, 4(4): 376-397.
    [6]
    YAO Y P, SUN D A, LUO T. A critical state model for sands dependent on stress and density[J]. International Journal for Numerical & Analytical Methods in Geomechanics, 2004, 28: 323-337.
    [7]
    YAO Y P, HOU W, ZHOU A N. Constitutive model for overconsolidated clays[J]. Science China Technological Sciences, 2008, 51(2): 179-191.
    [8]
    YAO Y P, HOU W, ZHOU A N. UH model: three dimensional unified hardening model for overconsolidated clays[J]. Géotechnique, 2009, 59(5): 451-469.
    [9]
    LADE P V, BOOP P A. Relative density effects on drained sand behavior at high pressures[J]. Soils and Foundations, 2005, 45: 1-13.
    [10]
    PESTANA J M, WHITTLE A J. Formulation of a unified constitutive model for clays and sands[J]. International Journal for Numerical and Analytical Methods in Geomechanics, 1999, 23: 1215-1243.
    [11]
    SHENG D C, YAO Y P, CARTER J P. A volume-stress model for sands under isotropic and critical stress states[J]. Canadian Geotechnical Journal, 2008, 45(11): 1639-1645.
    [12]
    ASAOKA A. An elasto-plastic description of two distinct volume change mechanisms of soils[J]. Soils and Foundations, 2002, 42(5): 47-57.
    [13]
    VERDUGO R, ISHIHARA K. The steady state of sandy soils[J]. Soil and Foundations, 1996, 36: 81-91.
    [14]
    姚仰平, 余亚妮. 基于统一硬化参数的砂土临界状态本构 模型[J]. 岩土工程学报, 2011, 33(12): 1827-1832. (YAO Yang-ping, YU Ya-ni. Extended critical state constitutive model for sand based on unified hardening parameter[J]. Chinese Journal of Geotechnical Engineering, 2011, 33(12): 1827-1832. (in Chinese))
    [15]
    ISHIHARA K. Liquefaction and flow failure during earthquakes[J]. Géotechnique, 1996, 43(3): 351-415.
  • Cited by

    Periodical cited type(2)

    1. 张远庆,陈勇,王世梅,王力. 岸坡渗流潜蚀模型试验系统变革研究. 三峡大学学报(自然科学版). 2025(02): 48-54 .
    2. 何健健,蒋希豪,汪玉冰. 离心模型试验中温度及孔隙率对砂土渗透系数的影响研究(英文). Journal of Zhejiang University-Science A(Applied Physics & Engineering). 2025(03): 177-194 .

    Other cited types(1)

Catalog

    Article views PDF downloads Cited by(3)
    Related

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return