• 全国中文核心期刊
  • 中国科技核心期刊
  • 美国工程索引(EI)收录期刊
  • Scopus数据库收录期刊
加瑞, 李逸群, 雷华阳, 姜宇轩. 基于三轴不排水有效应力路径的结构性剑桥模型的修正研究[J]. 岩土工程学报. DOI: 10.11779/CJGE20231243
引用本文: 加瑞, 李逸群, 雷华阳, 姜宇轩. 基于三轴不排水有效应力路径的结构性剑桥模型的修正研究[J]. 岩土工程学报. DOI: 10.11779/CJGE20231243
Research on the modification of structured Cam Clay model based on triaxial undrained effective stress path[J]. Chinese Journal of Geotechnical Engineering. DOI: 10.11779/CJGE20231243
Citation: Research on the modification of structured Cam Clay model based on triaxial undrained effective stress path[J]. Chinese Journal of Geotechnical Engineering. DOI: 10.11779/CJGE20231243

基于三轴不排水有效应力路径的结构性剑桥模型的修正研究

Research on the modification of structured Cam Clay model based on triaxial undrained effective stress path

  • 摘要: 室内外试验和工程实践都表明天然沉积黏土具有一定的结构性,因此建立结构性本构模型对准确预测天然黏土的力学响应和解决实际岩土工程问题具有重要意义。首先基于结构性黏土的三轴固结不排水试验的有效应力路径对结构性剑桥(SCC)模型进行了两点改进:①对附加孔隙比Δe的计算公式进行了修正,可以准确模拟结构性黏土超过临界状态线后的有效应力路径;②考虑了屈服面内的塑性即亚屈服特性,可以较好地模拟屈服面内的有效应力路径。然后利用修正结构性剑桥(MSCC)模型对结构性黏土的侧限压缩试验、三轴固结不排水和三轴固结排水试验进行了模拟计算,并与试验结果和SCC模型的计算结果进行了对比分析,结果表明MSCC模型可以更好的模拟结构性黏土的三轴不排水有效应力路径以及侧限压缩和三轴固结排水试验的应力应变曲线。最后对MSCC模型中的参数β(屈服面内塑性变形参数)、p'yi(初始结构屈服应力)、Δei(初始附加孔隙比)、b(结构破损速率)、γ(剪切引起结构破损的参数)和ω(反映结构性对塑性流动准则的影响)进行了参数敏感性分析,结果表明参数β影响结构性黏土屈服面内的有效应力路径,参数p'yi影响峰值强度,参数Δei影响残余强度,参数b和γ影响峰值后的强度衰减速率,参数ω影响强度开始衰减时的偏应变大小。

     

    Abstract: Both laboratory and in situ tests and engineering practice show that naturally sedimented clays have a specific structure. Therefore, establishing a structural constitutive model is of great significance in accurate predicting the mechanical responses of natural clays and solving practical geotechnical engineering problems. Firstly, based on the effective stress path of consolidated undrained triaxial test of structured clay, two improvements were made to the structured Cam Clay (SCC) model: (1) The formula for calculating the additional void ratio Δe was modified, which can accurately simulate the effective stress path of structured clay beyond the critical state line. (2) Considering the plasticity in the yield surface, i.e., subyielding characteristic, the effective stress path in the yield surface can be well simulated. Then, the modified structured Cam Clay (MSCC) model was used to simulate the confined compression test, the consolidated undrained and drained triaxial tests of structured clay. The calculation results were compared with the experimental results and the calculation results of the SCC model. The results show that the MSCC model can better simulate the triaxial undrained effective stress path and stress-strain curves of confined compression and consolidated drained triaxial tests of structured clay. Finally, the sensitivity analyses of parameters β (plastic deformation parameter in yield surface), p'yi (initial structural yield stress), Δei (initial additional void ratio), b (structure degradation rate), γ (shear-induced structure degradation parameter) and ω (reflecting the influence of soil structure on plastic flow criterion) in the MSCC model were carried out. The results show that parameter β affected the effective stress path in the yield surface of structured clay, parameter p'yi affected peak strength, parameter Δei affected residual strength, parameters b and γ affected strength degradation rate after the peak value, and parameter ω affected the magnitude of deviatoric strain when strength began to degrade.

     

/

返回文章
返回